The purpose of this document is to provide a guide for the Installation of a Edge Card onto a M1 or M2 board for the Metlogix Box.
1. Remove the Metlogix Box from the Comparator.
- M1 Metlogix Box which is shown below, can be removed by simply pulling up the box since it’s stationed by a Velcro strip.
2. Remove the screws on the top of the box.
3. Remove the top and the card.( Watch out for the Ribbon Cables.)
4. Remove the 2 screws shown by the screw drivers.
5. Take the nuts out of the pack and put the washer on the one shown.
6. Place the nuts in the holes where you removed the screws.
7. It should look like this:
8. Remove the plugs on the top.
9. Slide the card in place.
10. Screw the card down.
11. Insert the Ribbon Cable into the card.
12. Screw the card down.
13. Put the assembly back in the box, making sure to look out for the cables.
14. Put the screws in the cover.
15. Put the box back in the machine and power it up. (Leave the glass off.)
16. With a laptop and USB Cable, re-license the box.
17. You are Done.
Comments
0 comments
Article is closed for comments.